Tag Archives: Services

RANGE ROVER VOGUE REPAIRS

Range Rover Hub Bushes.

Range Rover Vogue Rear Hub Spherical Bushes.

This Range Rover came into us after failing its MOT on the rear hub lower spherical bushes having excessive movement.

Once we had removed the wheels and disconnected the lower suspension arms we could get a good look at the bushes and what we had to deal with.

The cir-clip that holds the bushes in place had completely rotted into the hub not allowing us to remove it in the conventional way, which meant we had to improvise!

range rover hub bearing
Cir-Clip rusted into the bush and hub.

As you can see from the above picture we had to grind into the bush until we reached what was left of the Cir-Clip to be able to remove it.

range rover swivel joint
Weaken the bush.

After grinding enough of the bush away to access and remove the Cir-Clip we cut into the side wall of the bush to make pressing it out easier.

range rover hub repair
Bush removed.

Voila, bush pressed out using our bearing and bush pulling tool, hole cleaned up and greased ready for the new bush to be pressed into place.

range rover hub tool
Bush tool.

Here you can see the bearing and bush pulling tool being used to press in the new bush, once the new bush is pressed in we just need to fit the new Cir-Clip and then begin the rebuild.

RANGE ROVER BUSH FITTED
New bush and Cir-Clip fitted.

New bush fitted and a new Cir-Clip fitted, after a quick rebuild the car was ready to go back to the customer for its MOT retest.

At Aarons Autos no job is to big or to small, we will en-devour to repair any car that comes through our doors.

Aarons Autos is the best car servicing garage in the world

Your friendly car garage in Derby

Give us a call at Aarons Autos for more info

Peugeot RCZ 1.6 THP 2011 stretched timing chain P0016.

Peugeot RCZ engine management light on Fault code P0016 and engine rattle.

We see quite a few Peugeot RCZ’s with engine management lights on and when diagnosed the fault code is P0016 Synchronization lack of coherence between engine speed sensor (crank sensor) and inlet camshaft sensor. This means that the engine is sensing that the timing of the vehicle engine is incorrect when running. The reason for this is that on this engine model (that is also fitted in the BMW MINI and other vehicles) the timing chain stretches due to either a mechanical component being worn, not being serviced regularly or low oil levels.

peugeot rcz timing chain aarons autos derby P0016

Peugeot RCZ 2012 fault code P0016

With the Diagnostic code read taken place we first remove the rocker cover and fit the engine timing pins to see how stretched the chain is but on this one we could see even with fitting the engine timing pins how far the chain had stretched.

peugeot rcz timing chain aarons autos derby P0016

Rocker cover removed with no timing pins fitted.

Having timed the crank and inserted the timing pin we went to time the cams and as you can see they were many teeth out. The two cam timing plates should meet together in the middle and both together.

peugeot rcz timing chain aarons autos derby P0016

Timing tool fitted showing how incorrect the timing was.

We removed the Chain and corrected the timing so that the new timing chain kit could be fitted.

peugeot rcz timing chain aarons autos derby P0016
peugeot rcz timing chain aarons autos derby P0016

Timing chain kit removed.

We always fit a brand new full timing chain kit that includes tensioner, chain, rocker cover gasket, guides, sprocket and VVT pulley.

peugeot rcz timing chain aarons autos derby P0016
peugeot rcz timing chain aarons autos derby P0016
peugeot rcz timing chain aarons autos derby P0016

All new parts fitted and timed up correctly.

With the new timing chain kit fitted and a oil and filter change completed the ecu was reset and the car ran allot quieter with no engine management light or code coming back on.

peugeot rcz timing chain aarons autos derby P0016

https://youtu.be/AkQTHUgsOSM Aarons Autos is the best car servicing garage in the world

Your friendly car garage in Derby

Give us a call at Aarons Autos for more info

Toggle panel: Platinum SEO Pack
Code editor selected

Suzuki Alto front shock absorber major failure.

Suzuki Alto Front Shock Absorber Failure

This Low miles Suzuki Alto got recovered into us with suspension failure causing the o/s/f wheel to be leaning out.

Suzuki Alto front strutt failure.

It was very apparent straightaway that the strut had failed due to corrosion.

Suzuki Alto strut failure due to corrosion.

We also checked the n/s/f and also found that it had a large crack in it.

Suzuki Alto strut cracking due to corrosion.

We replaced both front struts and a inner and outer cv boots due to them being torn and after checking the tracking the car was good to go.

Suzuki Alto front strut replaced.

Suzuki Alto tracking completed

Aarons Autos is the best car servicing garage in the world

Your friendly car garage in Derby

Give us a call at Aarons Autos for more info

Ford Transit Welding.

Ford Transit Chassis Cab Extra LWB for MOT Welding.

This Ford Transit extra LWB (Long Wheel Base) had been specially adapted for the customer many years ago to enable it to carry extra long loads. It came in to us for its annual MOT, whilst carrying out the MOT it became apparent that the extension section of the chassis which makes this van an ‘Extra LWB’ was made from a lower quality steel than the original chassis and was in very poor condition.

Corroded Chassis Leg & Cross Member

After removing the body from the chassis we could see what we had to deal with and realised we would have to completely replace the cross member as well as repairing the chassis legs.

Assessing the Corrosion

The structural integrity of the the chassis legs was still very good and it was just the thin outer skin that was holed and corroded so we decided to sleeve the complete chassis leg to increase the strength of the existing legs.

New Sleeve And Top Being Welded Into Place

“MOT Welding on Transit Van”

Once both chassis leg sleeves and tops had been welded into place it was time to align and fit the new cross member, the cross member also supports the prop shaft so needs to be perfectly in line as to not cause any vibrations.

Cross Member And Modified Prop Mount Fitted

Next job was to weld the top onto the cross member and seem seal and paint the chassis to help keep it protected.

Sealed & Painted

After completing this section there were a few plates to be made for the rear section of the chassis then the welding would be complete and we could refit the body.

One Rear Section Completed

“Time to refit the LWB body”

Body Bolted Back Into Place
Aarons Autos is the best car servicing garage in the world

Your friendly car garage in Derby.

Give us a call at Aarons Autos for more info

Aarons Autos Celebrating 10 Years

Aarons Autos 10-yearsThis year Aarons Autos celebrates its 10th year of business.

Opening its doors in 2004 with only Aaron, one ramp and a handful of loyal customers Aarons Autos was born.

Aaron’s back ground was in the Fleet Maintenance sector of the motor trade so this was the basis of which he was going to setup Aarons Autos.

The business has gradually grown by specialising in ‘Fleet Vehicle Maintenance‘ providing a valuable service to all kinds of companies in Derby and throughout the Midlands helping them keep their vehicles maintained.

In early 2010 Aaron decided to run a Motorsport section within Aarons Autos called Trackspeeduk, this would include Track Day Car and Race Car building, preparation, maintenance and support.

In 2012 Aarons Autos were asked to build and support a Race Car which would be entered into the MSVR Team Trophy Race Series, which went on to win several trophies throughout 2012 including a 1st place at Donington Park.

In 2013 Aaron and his workshop manager David Slater decided to build their own Race Car and enter into the same Race Series to see if they had what it takes to drive the cars as well as they could build them (all of which could not have been achieved without the generosity of their sponsors), they finished the season with one 2nd place and three 3rd places.

So onto 2014 Aarons Autos hope to offer their services to more Fleet customers giving them the same quality service they have been giving to their existing customers for the last ten years.

Also in 2014 Aarons Autos have three Race Cars (including their own) entered into the MSVR Team Trophy which will need preparation and maintenance throughout the year.